RailPro and Decoder Buddy

[Jeff1022]

I was talking with Nick of Nix Trainz at the recent St. Louis RPM meet and he told me that his "Decoder Buddy" board would work with a RailPro module.  I'm just getting my feet wet with RP, but his boards have a 21 pin receptacle and I believe the modules are a 9 pin.  So, how can this be true per him?  Has anyone been able to make these work together in some manner?  I also inquired about his "Stay Alive" capacitors and he said he had never tried it, but he did use another brand stay alive with a RailPro module once and it worked.  So, give it a try and see is all he had on that. 

Any thoughts from the group will be greatly appreciated.  Thanks. Jeff Youst

[G8B4Life]

Ring has both 21 pin and 9 pin LM's  available. The 9 pin LM would require an adapter harness to use the Decoder Buddy board, the 21 pin LM would fit directly.

As for "Stay Alive" devices, never used any so I can't answer that but in theory any Stay Alive should work however some that are built into factory motherboards in models do not work properly without the specific DCC decoder they were designed for seemingly due to a mismatch in control voltage levels. Ring has their own Stay Alive, the PBM which they try to spruik as the only safe Stay Alive for RailPro.

- Tim