Author Topic: Updating/Changing Locomotive Pictures on the HC-2 Controller  (Read 1483 times)

yvesmary

  • Fireman
  • **
  • Posts: 41
Updating/Changing Locomotive Pictures on the HC-2 Controller
« on: March 14, 2016, 10:39:32 PM »
Last night I successfully changed a picture of a loco on my controller. But I had trouble doing it.

I was going around in circles getting a "File in Use" message or a screen that said "Programmer Started" whatever that means.

From Tools on the main page to Update on the next, I'm not sure about the proper sequence from there. I tried various combinations from the third page until suddenly the new picture appeared. Now I don't remember what I did but I can't do it again tonight.

So here I am again asking for your help.

Thanks,
Yves in Ponoka

William Brillinger

  • Dispatcher (Admin)
  • Conductor
  • *****
  • Posts: 1138
    • Precision Design Co.
Re: Updating/Changing Locomotive Pictures on the HC-2 Controller
« Reply #1 on: March 14, 2016, 10:50:48 PM »
If the image you want to change is assigned to a module, you need to choose the new image and load it to the module then remove the old image. 
- Bill Brillinger, RPUG Admin

Modeling the BNML in HO Scale, owner of Precision Design Co., and RailPro Dealer.