« previous next »
Pages: [1]

Author Topic: Bachmann k27 additional lighting  (Read 9104 times)

Nickxlucas

  • Fireman
  • **
  • Posts: 5
Bachmann k27 additional lighting
« on: March 28, 2022, 11:22:01 PM »
Sorry newbie here. Just finished wiring up my bachmann large scale k 27. Wanting to add a rear light but the loco didn't originally have one so there no spot on the board. How would I add a rear light using the railpro module?
Logged

KB02

  • Engineer
  • ***
  • Posts: 86
Re: Bachmann k27 additional lighting
« Reply #1 on: March 29, 2022, 05:54:38 AM »
If the motherboard is the same as on this site: https://www.bachmanntrains.com/home-usa/k27_2010.php?k27page=3, then the J1 Pin 9 in the rear light for the tender.
Logged

Nickxlucas

  • Fireman
  • **
  • Posts: 5
Re: Bachmann k27 additional lighting
« Reply #2 on: March 29, 2022, 06:15:38 AM »
My 27 is the 455 with no rear light from factory. I repainted it to 463 quick has a rear light. So I've added a light to the tender but not sure how to wire it up
Logged

G8B4Life

  • Signalman (Global Mod)
  • Conductor
  • *****
  • Posts: 1241
  • I'll think of a catchy tag line one day
Re: Bachmann k27 additional lighting
« Reply #3 on: March 29, 2022, 08:50:14 PM »
If you've added a new light that isn't going to use any of the existing onboard electronics you would simply wire the new light straight to the wiring harness on the LM. Page 7 of the LM-4S-G manual (https://www.ringengineering.com/RailPro/Documents/LM-4SGInstructions.pdf) shows how.

- Tim
Logged
Pages: [1]
« previous next »