Good Afternoon All:
The saga continues:
I am doing a hard wire conversion of an ihc mehano 2-8-2 Mikado steam loco.
The decoder is an LM-2S
From the nine pin wiring harness, I am using the red to the right side pick up, black to the left side pick up, orange to the positive motor, grey to the negative motor and blue and white for the front light.
Before installing everything, I did a motor test with the above connections soldered appropriately, with the exception of hooking up the front light.
I put the engine, without tender, on the test track. Hit find product; product found LM-2S. Exit page.
Hit locomotives, hit no name engine, screen displays “button setup changed. Go to adjustments.” Exit.
Hit adjustments, hit save, save complete, hit next page x2, hit motor full load current, use auto set yes, hit start test, count down, momentary display of 100% then showing 0mA, redo start test, loco speed 100% then error-timeout, try a third time, error time out. The first two times the motor made a sound then stopped, the third time, no motor sound.
Thinking I had a short in the wiring harness, I got a new nine pin wiring harness and soldered directly to the terminals. Same results.
Thinking maybe a bad decoder, I tried a brand new LM-3S. Same results.
I put another dcc engine on the track. Everything ran fine.
Thinking the motor was bad on my Mikado, I hooked the motor leads to my dc power pack. It ran just fine. This motor is not the original motor. The old three pole was shot so I replaced it with a new five pole.
What am I doing wrong? Help.
Kind regards,
Max
