Hello Group:
This is my first install of an LM-2S module. Previously I have installed an LM-2 module successfully (1 light). This install is in a non-ready DCC loco. The loco will run fine in either direction. The sounds will work. I receive the message "OK - No Faults" until I attempt to use one of the light buttons, then the message changes to "Output Short" - "Short circuit detected in output. Check for wiring problems." I took the loco to my LHS and they installed a DCC decoder. Everything worked fine, including the light functions (3 lights - 2 LEDs with resistors) with the DCC decoder.
I have checked the various forums, and instructions found on this website, but did not come across anyone having this similar problem.
Does anyone have a suggestion as to what I need to do?
Mike Sullivan