« previous next »
Pages: [1]

Author Topic: Hard install  (Read 10643 times)

Abiqua

  • Fireman
  • **
  • Posts: 8
Hard install
« on: November 07, 2015, 10:43:39 PM »
I have two old but very nice locomotives that are not DCC ready. How difficult is it to hardwire in a 9 pin harness? Is there any place to find instructional documents or videos on how to install DCC harnesses which will allow use of an LM-2?
Logged
Bob -- Cottage Grove, Oregon
SP&S and Oregon Shortlines

William Brillinger

  • Dispatcher (Admin)
  • Conductor
  • *****
  • Posts: 1342
    • Precision Design Co.
Re: Hard install
« Reply #1 on: November 07, 2015, 11:01:47 PM »
What are the locomotives?
Logged
- Bill Brillinger, RPUG Admin

Modeling the BNML in HO Scale, owner of Precision Design Co., and RailPro Dealer.

nodcc4me

  • Conductor
  • ****
  • Posts: 688
  • RailPro Fan
Re: Hard install
« Reply #2 on: November 08, 2015, 08:51:39 AM »
It does depend on the locomotive, but the wiring for RP is the same as it is for DCC. Google "Wiring a locomotive for DCC",  and you will find plenty of information and videos on how to do it.
Logged
Al

Run your train, not your brain. Get RailPro. It's a no-brainer.

Abiqua

  • Fireman
  • **
  • Posts: 8
Re: Hard install
« Reply #3 on: November 09, 2015, 03:25:59 PM »
Hi Bill,

The two locos are a Roundhouse Alco RS-3 and a Stewart Baldwin VO-1000.
Logged
Bob -- Cottage Grove, Oregon
SP&S and Oregon Shortlines

William Brillinger

  • Dispatcher (Admin)
  • Conductor
  • *****
  • Posts: 1342
    • Precision Design Co.
Re: Hard install
« Reply #4 on: November 09, 2015, 03:39:07 PM »
Here are Soundtraxx's instructions for the Baldwin (PDF)

It should help you figure out the RailPro install for that one.
Logged
- Bill Brillinger, RPUG Admin

Modeling the BNML in HO Scale, owner of Precision Design Co., and RailPro Dealer.

Pages: [1]
« previous next »